WEBVTT

1
00:00:00.050 --> 00:00:09.550
This walkthrough adds a LoRaWAN sensor and follows a measurement through the gateway, network server and application.

2
00:00:16.400 --> 00:00:24.900
In Add Device, choose a LoRaWAN sensor and select the Dragino LHT65N model.

3
00:00:29.500 --> 00:00:36.900
Open IoT Operations and select LoRaWAN, then open the new sensor settings.

4
00:00:37.050 --> 00:00:47.450
The sensor uses over-the-air activation and a one-minute report interval; its enrollment credentials were prepared outside this recording.

5
00:00:49.950 --> 00:00:59.950
Select the temperature measurement and set a manual value so the uplink has a value we can verify.

6
00:01:03.950 --> 00:01:12.950
On the network server, enable the backhaul listener and choose the application topic and MQTT broker.

7
00:01:14.500 --> 00:01:24.000
On the gateway, enable the packet forwarder and point it at the same server and listener port.

8
00:01:24.450 --> 00:01:34.650
The server enrollment must match the sensor identity, activation mode, device profile and key; keep the key private.

9
00:01:38.200 --> 00:01:48.700
Enable both radio directions between this sensor and the gateway, because activation also needs a response from the network.

10
00:01:52.650 --> 00:02:03.650
Activate the sensor and wait for its state to become Joined; being powered on does not mean it has joined.

11
00:02:05.250 --> 00:02:14.250
Send a test uplink to generate a fresh measurement without waiting for the next periodic report.

12
00:02:14.700 --> 00:02:23.350
Confirm the reported temperature, then distinguish gateway reception, server acceptance and application delivery.

13
00:02:25.350 --> 00:02:35.850
The events list shows the stages separately, so an earlier radio event alone is not proof of application delivery.

14
00:02:36.000 --> 00:02:46.000
Reload the page and confirm the saved sensor, gateway and server settings before continuing with the next exercise.
