WEBVTT

1
00:00:00.100 --> 00:00:09.200
This lab compares the ordinary shortest route with a traffic-engineered tunnel across three IOS XR routers.

2
00:00:15.900 --> 00:00:26.400
Without a tunnel, traffic goes directly from HEAD to TAIL; the transit router MID is not on that path.

3
00:00:27.200 --> 00:00:36.700
OSPF neighbours are established, and traffic engineering is enabled in the same area on all three routers.

4
00:00:37.800 --> 00:00:47.800
RSVP can reserve one thousand kilobits per second through MID, but only one hundred on the direct link.

5
00:00:50.200 --> 00:00:58.850
On HEAD, create tunnel interface fifteen hundred and use Loopback zero as its unnumbered source.

6
00:01:01.650 --> 00:01:11.650
Set the remote loopback as the destination, select a dynamic path and request five hundred kilobits per second.

7
00:01:14.150 --> 00:01:22.750
Enable autoroute announce and commit the configuration so eligible OSPF traffic can use the tunnel.

8
00:01:23.800 --> 00:01:34.800
The tunnel is operational, and its selected path goes through MID because the direct link cannot satisfy the bandwidth request.

9
00:01:43.450 --> 00:01:52.950
The route now names the tunnel, while the MPLS forwarding table on MID contains its transit label.

10
00:02:09.250 --> 00:02:19.750
Send traffic to the remote loopback, then inspect the forwarding table again to see the switched byte counter increase.

11
00:02:26.900 --> 00:02:34.300
Traceroute also follows MID, confirming that packets take the traffic-engineered path.

12
00:02:39.600 --> 00:02:50.600
Now shut the link from HEAD to MID; the tunnel goes down because the remaining path has insufficient reservable bandwidth.

13
00:02:52.550 --> 00:03:04.050
Ordinary IP routing still reaches TAIL over the direct link, so underlay reachability alone does not prove the tunnel is up.

14
00:03:18.850 --> 00:03:27.850
Restore the link and the tunnel recovers through MID; verify the path and successful traffic again.

15
00:03:30.100 --> 00:03:41.900
This walkthrough uses a single-area dynamic IPv4 tunnel with bandwidth admission and autoroute, without fast reroute or priority preemption.
