IoT · Episode 07 · 2:46

Onboard a LoRaWAN sensor and follow its uplink

Add a Dragino LoRaWAN sensor, configure its gateway and network server, join the network and follow a temperature reading through application delivery in IoT Operations.

English narration and on-screen explanations. Read the narration transcript.

Chapters and transcript times will be ready shortly. You can use the video’s Play control or open the MP4 below.

Chapters
Open MP4 · Download transcript · English captions

Narration transcript

The English narration in this video. Select a time to watch that moment.

  1. This walkthrough adds a LoRaWAN sensor and follows a measurement through the gateway, network server and application.

  2. In Add Device, choose a LoRaWAN sensor and select the Dragino LHT65N model.

  3. Open IoT Operations and select LoRaWAN, then open the new sensor settings.

  4. The sensor uses over-the-air activation and a one-minute report interval; its enrollment credentials were prepared outside this recording.

  5. Select the temperature measurement and set a manual value so the uplink has a value we can verify.

  6. On the network server, enable the backhaul listener and choose the application topic and MQTT broker.

  7. On the gateway, enable the packet forwarder and point it at the same server and listener port.

  8. The server enrollment must match the sensor identity, activation mode, device profile and key; keep the key private.

  9. Enable both radio directions between this sensor and the gateway, because activation also needs a response from the network.

  10. Activate the sensor and wait for its state to become Joined; being powered on does not mean it has joined.

  11. Send a test uplink to generate a fresh measurement without waiting for the next periodic report.

  12. Confirm the reported temperature, then distinguish gateway reception, server acceptance and application delivery.

  13. The events list shows the stages separately, so an earlier radio event alone is not proof of application delivery.

  14. Reload the page and confirm the saved sensor, gateway and server settings before continuing with the next exercise.

Back to all IoT videos