Labs · Episode 37 · 4:06

Configure PC network settings

Configure a Linux PC with static IPv4, DHCP, DNS and IPv6 settings. Verify lab connectivity, recover a failed address request and reopen the saved configuration.

English narration and on-screen explanations. Read the narration transcript.

Chapters and transcript times will be ready shortly. You can use the video’s Play control or open the MP4 below.

Chapters
Open MP4 · Download transcript · English captions

Narration transcript

The English narration in this video. Select a time to watch that moment.

  1. Select the Linux PC, open Desktop Network Settings and choose the connected interface.

  2. Set a static IPv4 address, prefix length, gateway and DNS server for this prepared lab.

  3. In the terminal, verify the address and route, then ping a destination beyond the gateway.

  4. Use the lookup command to resolve a hostname served by this lab.

  5. Switch IPv4 to Automatic DHCP and apply the change.

  6. Inspect the address, DNS, and route that DHCP learned.

  7. Power off the DHCP server and retry to see a missing-offer error while the existing address remains.

  8. Power the DHCP server back on and retry the request.

  9. Configure a static IPv6 address, prefix, and gateway for this lab.

  10. Verify the IPv6 route and ping the IPv6 gateway.

  11. Request an automatic IPv6 address and inspect the address that was actually received.

  12. Verify both stacks and confirm the second interface was left untouched.

  13. Enter malformed DNS, see it rejected, and recover with valid settings.

  14. Save the settings, reopen them, and verify the choices that were saved.

Back to all Labs videos